| 0 Items | 0 Ft |
Instructions – how to fill latex and foil balloons
| 1. Place the box upright on a flat surface. | ||||||
 |
 |
|||||
| 2. Open the box at the top (at „OPEN HERE”) and then pull out the pre-cut portion of cardboard. | ||||||
 |
 |
|||||
| 3. On the side of the box, push through the rounded pre-cut portion of cardboard to clear the filling valve. Remove the plastic screw cap from the valve outlet. | ||||||
 |
|
|||||
| 4. Screw hand-tight the wide end of the filling nozzle all the way onto the valve outlet and make sure the thread is even and straight. Please do not use any tools. | ||||||
 |
 |
|||||
| 5. Open the valve by turning the handle counter-clockwise. | ||||||
 |
|
|||||
| 6. Place the balloon over the nozzle. | ||||||
 |
 |
|||||
| 7. Hold balloon neck firmly and press the valve down gently to inflate the balloon. | ||||||
 |
 |
|||||
| 8. Stop pressing when desired size is achieved. | ||||||
 |
 |
|||||
| 9. Nip the neck of the balloon with finger and thumb and remove the balloon from the nozzle. Tie the balloon neck into a single knot. After inflating the balloons, always close the valve tightly by turning the handle clockwise. Please leave the filling nozzle and connection tube screwed to the valve outlet. This will prevent balloon gas from accidentally leaking out. | ||||||
 |
 |
|||||
 |
||||||
|
||||||
